|
|
|
Kto jest w sklepie?
Sklep przegląda 6014 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
XV-S40BK/XV-S42SL/XV-E100SL
Disassembly method
There is a part different from the photograph according to the model and the destination though explains this disassembly method by using XV-E100SL.
<Main body> Removing the top cover (see Fig.1)
1.Remove the two screws A attaching the top cover on both sides of the body. 2.Remove the three screws B attaching the top cover on the back of the body. 3.Remove the top cover from the body by lifting the rear part of the top cover. ATTENTION: Do not break the front panel tab fitted to the top cover. CN703 CN702 C C Ax2 Fig.1 B F Lug wire Mechanism assembly B
B
Removing the mechanism assembly (see Fig.2,3)
* Prior to performing the following procedure, remove the top cover. * There is no need to remove the front panel assembly. 1.Remove the three screws C attaching the mechanism assembly on the bottom chassis. 2.Remove the two screws F attaching the lug wire and main board on the bottom chassis. 3.The servo control board is removed from the connector CN961 and CN701 connected with the main board respectively. 4.Remove the mechanism assembly by lifting the rear part of the mechanism assembly. CN701 Fig.3 CN961
Main board Servo control board
C Main board Fig.2
Mechanism assembly
F
Removing the servo control board (see Fig.4)
* Prior to performing the following procedure, remove the top cover and mechanism assembly. 1.Disconnect the card wire from connector CN201 and CN202 on the servo control board respectively. 2.Disconnect the flexible wire from connector CN101 on the servo control board from pick-up. < ATTENTION > At this time, please extract the wire after short-circuited of two places on the wire in part a with solder. Please remove the solder two places of part a after connecting the wire with CN101 when reassembling. 3.Two places in hook b are removed, the servo control board is lifted, and it is removed. Fig.4
Hook b
Hook b
Servo control board
1-7
|
|
|
> |
|
