Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 26 (kliknij aby zobaczyć)
English
Continued
� If �TRACK PROTECTED� appears, the selected track has been write-protected by another component. You cannot edit such a protected track. To cancel the editing, press TITLE/EDIT button.
JOIN Function
This function allows you to join two adjacent tracks into one track. � To quit any time during editing process, press TITLE/ EDIT button.
5
Press SET button when you find the point where you want to divide the track. The MD recorder repeats the selected point � a portion of three seconds length following the dividing point.
1 2
Insert an MD you want to edit into the MD loading slot. The MD IN lamp lights orange. Press TITLE/EDIT button until �JOIN?� appears in the display window.
� If you have selected a wrong track number, press CANCEL button then select the correct track.
3
Press SET button.
6
Rotate MULTI JOG dial ( < / > button also available) to precisely adjust the dividing point. � You can shift the dividing point up to ±128. This range (±128) corresponds to approximately ±8 seconds from the original point (Position 0).
4 5
Rotate MULTI JOG dial to select the two adjacent tracks you want to join (< / > button also available ). Press SET button.
When you stop rotating MULTI JOG dial, the system repeats the newly selected dividing point.
7
When you find the right position, press SET button. �PUSH ENTER� appears in the display window.
8
Press ENTER button to finish the editing procedures. � If you want to cancel the editing, press CANCEL button.
� If you have selected wrong tracks, press CANCEL button, then select the correct tracks by rotating MULTI JOG dial (< / > button also available). � If you want to cancel the editing, press TITLE/EDIT button. � If �TRACK PROTECTED� appears, the selected track has been write-protected by another component. You cannot edit such a protected track. To cancel the editing, press TITLE/EDIT button.
6
Press ENTER button to finish the editing procedures.
9
Press 0 (eject) button to eject the MD. �WRITING� appears while the editing you have made is being recorded onto the MD.
7
To join the divided tracks again, see the JOIN function.
Press 0 (eject) button to eject the MD. �WRITING� appears while the editing you have made is being recorded on the MD.
To divide the joined tracks, see the DIVIDE function.
