JVC RX-8000VBKJ
Instrukcja Obsługi

On the front panel: You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.
DSP MODE

4. Adjust the effect level.
1) Press BALANCE/SURROUND ADJUST repeatedly until �DSP EFFECT� appears on the display. The display changes to show the current setting. 2) Turn MULTI JOG to select the effect level. As you turn it, the effect level changes as follows:

BALANCE/SURROUND ADJUST

MULTI JOG

1. Press DSP MODE repeatedly until �THEATER� appears on the display.
The Ÿ PRO LOGIC and DSP indicators also light up on the display.

DSP EFFECT 1

DSP EFFECT 2

DSP EFFECT 3

2. Adjust the speaker output levels.
1) Press BALANCE/SURROUND ADJUST repeatedly until one of the indications appears on the display. �CENTER LEVEL�: To adjust the center speaker level. �REAR L LEVEL�: To adjust the left rear speaker level. �REAR R LEVEL�: To adjust the right rear speaker level. 2) Turn MULTI JOG to adjust the selected speaker output level (from �10 dB to +10 dB). 3) Repeat 1) and 2) to adjust the other speaker output levels.

DSP EFFECT 5
BALANCE/SURROUND ADJUST

DSP EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

Activating the DSP Modes
You can use only one DSP mode at a time. When a DSP mode is activated, another DSP mode is canceled if in use.
MULTI JOG

For Dolby Pro Logic, Dolby Digital, and DTS Digital Surround

1. Press SURROUND ON/OFF so that the lamp on the front panel button lights up.
BALANCE/SURROUND ADJUST

3. Adjust the center tone.
1) Press BALANCE/SURROUND ADJUST repeatedly until �CENTER TONE� appears on the display. The display changes to show the current setting. 2) Turn MULTI JOG to select the center tone level you want. � As you turn it, the display changes to show the following:

� Each time you press the button, the Dolby/DTS Surround turns on and off alternately.
SURROUND ON/OFF
SURROUND ON/OFF

MULTI JOG

On the front panel

On the remote control

2. Select and play a sound source.
CENTER SHARP1 CENTER FLAT
(Canceled)

CENTER SHARP2

CENTER SOFT 1

CENTER SOFT 2

To make the dialogue clearer, select �CENTER SHARP1� (little) or �CENTER SHARP2� (much). To make the dialogue softer, select �CENTER SOFT 1� (little) or �CENTER SOFT 2� (much). When �CENTER FLAT� is selected, no adjustment is applied.

� To enjoy Dolby Pro Logic, play back a software encoded with Dolby Surround and labeled with DOLBY SURROUND mark. � To enjoy Dolby Digital, play back a software encoded with Dolby Digital and labeled with mark. � To enjoy DTS Digital Surround, play back a software encoded with DTS Digital Surround and labeled with mark.
DIGITAL

To cancel the Dolby/DTS Surround mode
Press SURROUND ON/OFF again so that the lamp on the front panel button goes off. (�SURROUND OFF� appears on the display.)
SURROUND ON/OFF
SURROUND ON/OFF

On the front panel

On the remote control

29