Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 37 (kliknij aby zobaczyć)
Adjusting the Volume
You can adjust the volume level only while the unit is turned on. Turn the VOLUME +/� clockwise to
VOLUME
Reinforcing the Bass Sound
The Hyper Bass Sound function provided for this unit can enhance the bass sound while listening to any source at low volume. � You can use this function only for playback. To turn on the function, press and hold HBS/ PRESET EQ for more than 1 second so that the HBS indicator appears on the display.
HBS
+
increase the volume or counterclockwise to decrease it. � The volume level can be adjusted in 31 steps (00 VOL to 30 VOL).
S /P E HS B/P QE
When using the remote control, press VOLUME + to increase the volume or press VOLUME � to decrease it.
To turn off the sound temporarily
To turn off the function, press and hold the button for more than 1 second again so that the HBS indicator goes off from the display.
On the remote control ONLY:
Press MUTING. The sounds is turned off and the MUTING indicator appears on the display. To restore the sound, press MUTING again. The MUTING indicator goes off. � Adjusting the volume level also cancels the muting.
Selecting the Sound Modes
You can select one of the 5 preset sound modes. SEA (Sound Effect Amplifier) modes: CLASSIC: Good for classical music. ROCK: Boosts low and high frequency. Good for acoustic music. POP: Good for vocal music. JAZZ: Good for jazz music. FLAT: Normal sound. � This function only affects the playback sound, but does not affect your recording. To select the sound modes, press HBS/ PRESET EQ repeatedly until the indicator for the sound mode you want appears on the display. � Each time you press the button, the sound modes change as follows:
CLASSIC FLAT JAZZ POP ROCK
For private listening Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.
DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER you cannot adjust the volume level while the unit is on standby.
