JVC HR-DD740U
Instrukcja Obsługi

44 EN
MENU
M B E R " 8 "

TIMER RECORDING (cont.)
You can directly program the VCR�s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer ( pg. 7 or 9).
C H

On-Screen Timer 1 Programming
N

LOAD A CASSETTE

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR. � The VCR comes on, and the counter is reset, automatically.

Turn on the TV and select the VCR channel 3 or 4 (or AV mode).

ACCESS ON-SCREEN MENU

2
OK
¢ ¢

Press MENU as many times as necessary to bring up the Main Menu screen.

ACCESS PROGRAM SET SCREEN

q

2

2

3 4

Make sure the highlight bar (arrow) is on "PROGRAM SET", then press OK.

SELECT PROGRAM NUMBER
Press the appropriate NUMBER keys or CH5� or TIME SCAN% � to select a vacant program number, then press OK. The first time you set the timer programming function, all the PRESS NUMBER KEY (O�9) OR (5,�), THEN (OK) program numbers will be PRESS (MENU) TO END blank; in this case just press OK when the Program Set screen appears.
DATE START STOP CHANNEL PROGRAM 1 � �/� � � �:� � AM � �:� � AM � � SP

1 4 7 8 0

2 5 9

3

6

NUMBER NUMBER "9"

SET PROGRAM INFORMATION

CH
1 ¶ 4

5

3 7 8

¡

Press the appropriate NUMBER keys to set the date, start/stop time and channel number. Press CH5� or TIME SCAN% � to set AM/PM and tape speed (SP or EP). Press OK after AM/PM, channel number and tape speed settings. * If you are using a DBS receiver, see "ATTENTION FOR DBS RECEIVER USERS" on next page. � Any information comprised of 1 digit (except the channel number) should have a "0" entered before it. � It is possible to set all information using the CH5� or TIME SCAN%� button. (In this case, press OK after each setting.) Do not use the CH � or TIME SCAN� button to set the date. � At the Program Set screen, the setting that can be set blinks. When setting of a highlighted item is completed, the highlight bar moves down by 1 line to the next item. ** You can record selected programs at the same time every weekday, or once a week. Before entering the month, press NUMBER key "WEEKLY" or �9� (WEEKLY). Either "DAILY" or�8� (DAILY)appears. Press again and "DAILY" or "WEEKLY" disappears. For weekly recording, the desired date for the day of the week must be entered.

U

¢

MENU OK

TIME SCAN

EXAMPLE
If you program the VCR to timer record a show on December 24 on channel 40 from 12:00 noon to 1:00 PM in SP mode, the screen will look like this:
PROGRAM 1 DATE START STOP CHANNEL 12/24 12:00 1:00 40 WED PM PM SP

PRESS NUMBER KEY (O�9) OR (5,�), THEN (OK) PRESS (MENU) TO END