Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 39 (kliknij aby zobaczyć)
CAPTURING IMAGES (cont.)
EN
39
Changing the transfer speed
The default setting is 57600bps. Depending on the PC in use, transmission errors may occur. In this case, change to a lower serial speed setting, however, the rate of image transfer will be slower.
1 Select [Transfer speed�] in the [Device] menu. 2 Select the desired setting. 3 Click [OK].
2 3
Changing the image size
You can select the size of an image to be captured.
1 Select [Auto save settings...] in the [Capture] menu.
The [Data save settings] dialog box appears.
2 Select the image size from a list of generic sizes. 3 Click [OK].
NOTE: You can also change the size of an image after capturing. ( pg. 42) Note that if an image is enlarged to the size larger than its original, it will take on a mosaic appearance.
2
3
Changing the connecting port
If you connect two or more serial devices to the PC, select the connecting port depending on the camcorder in use.
1 Select [Connecting Port...] in the [Device] menu. 2 Select the desired connecting port. 3 Click [OK].
